Struck by running powered equipment during maintenance, cleaning, testing · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Ingersoll Rand, Inc., 1419 Illinois Avenue, SHEBOYGAN, WISCONSIN 53081
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was setting up dies on a die casting machine. The machine's ram unexpectedly returned from the down position and caught the tip of the employee's right thumb against a pinch point in the shot sleeve. The employee suffered an open fracture/amputation to the thumb tip. The machine was not locked out at the time.
Amputation Finger or thumb tip(s), nail(s) Casting machinery
An employee was servicing a reciprocating air compressor when their left middle finger was caught in a belt motor pulley sheave while manually moving the belt. Approximately 1/4 inch of the employee's left middle fingertip was amputated.
An employee was using a grooving machine to put a lip on the edge of a pipe. His glove was caught in the machine, which amputated three of his fingers.
An employee was operating an aluminum trim press. While reaching down to put another part in a bin, their right hand was crushed by the press resulting in a partial amputation of a finger.
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
More severe injuries in this industry (NAICS 333912)
An employee was spotting a crane when the load (fabricated skid for packaged equipment) that was being picked up came loose and fell on the employee. The employee sustained a crush injury resulting in a fractured pelvis.
Employee 1 was cleaning a paint gun using paint thinner when employee 2 started a lighter nearby and the cup of paint thinner ignited. Employee 2 dropped the cup and the ignited paint thinner spilled, causing burns on employee 2's arms, legs, hands, and face.
An employee was servicing a reciprocating air compressor when their left middle finger was caught in a belt motor pulley sheave while manually moving the belt. Approximately 1/4 inch of the employee's left middle fingertip was amputated.
An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.