Struck by swinging or slipping object, other than handheld, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Total Grain Marketing, LLC, 397 S Locust St., NEOGA, ILLINOIS 62447
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
On April 12, 2023, an employee was pulling a stack of metal connecting sheets off the forks of a skid steer and stacking them on a trailer. After pulling a stack of 6-7 sheets off, the sheets shifted and the metal edge went into the employee's left middle finger, resulting in an amputation above the top knuckle.
AmputationFinger(s), fingernail(s), n.e.c.Sheet metal
More severe injuries at Total Grain Marketing, LLC
On October 5, 2024, a crew was staging the last string of railcars to be loaded when the injured employee stepped forward and tripped on a railroad tie, causing his right foot to be on the rail. A staged railcar rolled forward and caught his foot between the wheel and the rail. The employee was hospitalized for amputations to toes.
On November 1, 2023, four employees had just adjusted a conveyor belt from the top of a grain bin. The conveyor belt was then energized and caught an employee's right arm/hand and caused a fractured/dislocated right ulna, tears to tendons in the forearm, and required a skin graft.
On July 1, 2020, an employee was sweeping soy beans and cleaning up the flat storage facility when the employee slipped on spilled beans and fell to the concrete floor. The employee suffered a hip fracture, requiring hospitalization and surgery.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 115116)
An employee was opening train car hatches on top of a train. The train was backing up to scan the cars in when the employee's foot became stuck. He was then dragged across two rail cars sustaining a concussion and a toe injury.
Employees were attaching a new liquid valve to an ammonia nurse tank. The wrench slipped and one employee fell off the side of a truck bed, landing on the ground and suffering a head laceration and spinal cord swelling.
An employee changed the tire and rim of a fertilizer tractor. The tire and rim were then put on the forks of a forklift. The tire and rim fell off the forks onto the employee's lower right leg causing fractures above the ankle.
An employee was inspecting rail cars from the top to ensure they were ready to accept grain for shipment. The rail car moved and he ducked to avoid the grain spout, which snagged his fall protection, causing him to fall into the rail car. His fall protection caught him, but he struck the wall of the car and suffered facial injuries including a potential orbital fracture.
An employee was attempting to seal a leak at the strainer plug located on a pressurized anhydrous ammonia toolbar. The employee was tightening a plug on the strainer using a wrench when the plug failed and a burst of anhydrous ammonia hit the employee in the face and torso. The employee suffered chemical burns to the eyes and mouth as well as the left side of their head, neck, and shoulder.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.