Explosion of nonpressurized vapors, gases, or liquids · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Harsco Environmental, 1 Steel Dr Paul Bayou gate, CALVERT, ALABAMA 36513
on — Third or fourth degree heat (thermal) burns, affecting the nonclassifiable.
Final narrative
An employee was operating an excavator with a hammer attachment. As the employee began hammering the pot and creating a hole in the slag crust, the slag hit the water and hot material was projected towards the equipment. The employee sustained second and third-degree burns to 10.5% of their body.
HospitalizedNonclassifiableMolten or hot metals, slag
An employee was lighting the pilot light on a water heater. Gas ignited, causing a flash fire and explosion at the residential property. The employee suffered burns to the head, neck, upper torso, and upper extremities.
An employee was preparing a reach in cooler (fry cooler) and charging the system with refrigerant (R290)with his gauges. When the employee removed the gauges from the liquid line service valve, the refrigerant immediately escaped, and the liquid refrigerant exploded due to an unknown ignition source. The employee was burned on the face, hands, abdomen and knees.
An employee was lighting a gas stove/pizza oven when an explosion occurred due to a natural gas buildup. The employee sustained first- and second-degree burns to the face, neck, arms, hands, and legs.
An employee was re-lighting a sulfur burner while another employee increased the pressure on the gas valve. A gas explosion occurred. The employee sustained second-and third-degree burns to their arm, hand, chest, abdomen, and neck.
More severe injuries in this industry (NAICS 423930)
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
A shear operator's hand and fingers were caught in a machine's point of operation. The operator's right index finger was crushed and was partially medically amputated.
An employee was operating a forklift. He parked on a ramp and got off the forklift to retrieve material, at which point the forklift rolled backward and ran over his leg. The leg was broken and he was hospitalized, requiring surgery.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.