Struck by object or equipment, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Day & Zimmermann, 6200 FM 3387, CHRISTINE, TEXAS 78012
on — Amputations, affecting the toes(s), toenail(s).
Final narrative
An employee was working on a 35,000-pound I.D. fan. As the employee rotated the blades with his foot, the blades continued to spin, lacerating his right foot and amputating a toe.
An employee tripped over a junior I-beam about 4 feet long and 6 inches tall that was installed for circulating water valves and fell to the ground, resulting in a broken right-side rib.
An actuator got stuck on a rusted stud and did not release. An employee tried to unjam the actuator and it moved, pinching his finger against the base of the pipe. His right index fingertip was amputated.
An employee injured his finger with a battery power drill while dismantling scaffolding. The employee's glove got caught in the drill and twisted. The injury required a partial amputation of the tip of his right ring finger.
An employee was inspecting a bridge repair project. A gas-powered, walk-behind pavement saw, being used 12 feet away from the employee lunged forward, cutting his left foot. The employee's fourth toe was amputated and he was hospitalized.
An employee had been reviewing an insulated glass unit. The employee was placing the glass unit back in its box when it slipped out of the box and a chipped corner lacerated the employee's left hand.
An employee was on a truck while using a clamp to secure a quartz slab to an A-frame on the truck. A gust of wind pushed the slab onto the employee, resulting in a dislocated right shoulder and wrist.
An employee was shearing off two inches of metal when the metal kicked up and struck his hand. The employee's left ring and middle fingertips were amputated.
An employee was setting up a cable tugger. A pin in the tugger came out, causing the equipment to move forward and strike his right middle finger. The fingertip was medically amputated.
More severe injuries in this industry (NAICS 238990)
A crew was relocating a dumpster (containing approximately 200 pounds of demolished wire) to access the uninterruptible power supply (UPS) units they were servicing. During movement of the dumpster, a section of carpet tile dislodged from the floor, causing an employee to lose his footing, slip, and fall. He landed on his right wrist, resulting in a fracture.
An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.
An employee was using an aluminum extension ladder to remove gutters at a height of approximately 20 feet. As they were removing the gutters, part of the gutter collapsed and struck the ladder, causing it to move sideways. The employee fell from the ladder and sustained fractures to ribs on the left side and their right forearm.
An employee was using an electric saw to cut a piece of wood for a fence. The saw slipped out of his hand and lacerated his left leg. He was hospitalized.
An employee was erecting a scaffold. A side bracket was not secure. The employee stepped on the bracket to test it and fell 18 feet to the concrete floor resulting in fractures to the ankles and femurs. He was not using fall protection equipment.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.