Teague Electric Construction, Inc

An employee was drilling a hole in a wall. When the drill came through the wall, it struck his index finger and amputated the tip.

An employee was inspecting a bridge repair project. A gas-powered, walk-behind pavement saw, being used 12 feet away from the employee lunged forward, cutting his left foot. The employee's fourth toe was amputated and he was hospitalized.

An employee had been reviewing an insulated glass unit. The employee was placing the glass unit back in its box when it slipped out of the box and a chipped corner lacerated the employee's left hand.

An employee was on a truck while using a clamp to secure a quartz slab to an A-frame on the truck. A gust of wind pushed the slab onto the employee, resulting in a dislocated right shoulder and wrist.

An employee was shearing off two inches of metal when the metal kicked up and struck his hand. The employee's left ring and middle fingertips were amputated.

An employee was working on a 35,000-pound I.D. fan. As the employee rotated the blades with his foot, the blades continued to spin, lacerating his right foot and amputating a toe.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.