MMC Materials, Inc

A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.

An employee was on top of a bulk haul tractor trailer preparing to load the trailer with cement. They lost footing and fell to the ground. The employee was hospitalized with fractured ribs.

An employee walking along the catwalk on the back of an 18-wheeler fell 3 feet to the ground and sustained a compression fracture to the L1 vertebra.

A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.

On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.

An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.

An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.

An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.

An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.

An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.

A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.