Louis-Company, LLC

An employee was struck by a pickup truck after the driver of a truck mounted attenuator struck the pickup, pushing it into the employee. The employee sustained a fractured hip, a fractured foot, and a traumatic brain injury.

Employees were preparing to clean the eastbound lanes of a highway bridge when a vehicle swerved and struck the arrow board trailer and truck. The injured employee was then struck by the trailer and suffered a femur fracture.

An employee and a co-worker were preparing to block off the side of a road for a utility crew. The employee was picking up traffic cones while the co-worker was towing an arrow board with a truck. A vehicle crossed two lanes of traffic and entered the work zone, striking the arrow board that was being towed. The board subsequently struck the employee, resulting in a fractured left hand, fractured ribs on the right side, and a contusion to their right forearm.

An employee was outside a company truck, placing safety cones around it to secure a working area. Two vehicles collided on the road; one of them then went out of control and struck the employee, who suffered broken ribs, a broken orbital socket, hip and leg injuries, and a concussion.

Employees of Ganim Company were setting up a work zone when a vehicle crashed into a company buffer van from behind. The van was pushed into a company truck with an arrow board attached to the back. The truck then struck three employees that were on foot. Two employees received scrapes and bruising. The third employee sustained a broken fibula and a hole in his leg.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.