Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Defense Commissary Agency, 1310 Edwards Street, GOLDSBORO, NORTH CAROLINA 27534
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was using a band saw to cut beef into one-inch steaks. As he was adjusting an uneven portion of meat, the employee's left middle finger contacted the blade, resulting in a fingertip amputation.
An employee was cutting meat. While using the push plate with her right hand, her left hand slipped between the blade and the meat. The blade grabbed her cotton glove, fracturing and amputating her left ring fingertip.
An employee was processing boneless beef using the band saw. She finished and powered it down. She then began clearing the cutting surface when her right ring finger contacted the blade, resulting in amputation of one-quarter of the fingertip.
An employee was operating a forklift behind the store when the forklift fell off the dock and rolled onto its side. The employee was hospitalized with a possible broken pelvis, arm, and rib.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was on a four-step work stand while sanding an area of an aircraft. He was climbing down the work stand when he tripped over an air hose and fell to the level below, resulting in a fractured femur.
A Bureau of Land Management (BLM) employee was assisting a fire crew with clearing a forest trail. The employee was struck in the left leg by a fire-rated chainsaw. The chainsaw struck the employee underneath their chaps and above their boot. The employee was hospitalized and required surgery.
An employee handed a fuel hose to another employee at a gas station pump and then turned around, tripped over the hose, and fell to the ground. The employee was hospitalized with a fractured hip.
An employee was conducting fire suppression operations on a wildfire. He pulled a hose from the engine. He then charged the hose and began to put on his gloves. A flareup occurred and the employee sustained burns to his face and hands.
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
An employee was preparing hot melted butter on a flat-top grill and placing it in small containers once it was melted. As she turned to set the container down, it slipped out of her hand and landed on the grill. Butter splashed up and hit her in the face. The employee suffered second-degree burns to her right eye and the right side of her head and face, as well as first-degree burns to her right forearm.
An employee pulled into the customer's driveway, parked, and exited the vehicle. He opened the sliding side door on the vehicle to retrieve a package. The customer began backing their vehicle out of their garage and it struck the employee in the back of his left leg. He was pinned him between the two vehicles, causing contusions and lacerations.