American Alloy Steel, Inc.

An employee was using electrical magnets to lift a 7,351-pound steel plate onto the burning table of a plasma cutter. The steel plate slipped and fell onto the employee's finger, resulting in a partial amputation of the left little finger.

An employee was reading the numbers off the bottom of a steel plate weighing 9,000 pounds as it was being lifted by a crane operator. The steel plate swung out and struck the employee in the chest, resulting in internal trauma that required hospitalization.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

A steel tube fell from a straddle truck onto an employee's foot, causing the steel toe of the employee's shoe to press into the employee's left foot. The employee sustained fractured phalanges and was hospitalized.

An employee was unloading materials from the back of a flatbed trailer. The employee fell off the back of the trailer approximately 4 feet to the ground below, resulting in a fractured left collarbone and fractured ribs. The employee was hospitalized.

An employee was bending material in a mechanical brake press when the press rotated and caught his right hand. His finger was crushed between the die and a steel plate, resulting in amputation of the finger.

An employee was cleaning pans containing adhesive by pouring acetone into the pans. After soaking, the employee used a plastic spatula to scrape the paint from the pan. During scraping, a fire spontaneously started underneath the employee near the pan. The employee threw the container of acetone out of the way to avoid it catching on fire, and spilled acetone onto his clothing, causing the fire to spread. The employee suffered burns to both hands and the right calf.

The injured employee was assisting a co-worker to transfer a V-baffle (large piece of angle iron weighing 736 lbs.) into a vessel shell. The injured employee stepped off the end of the vessel and fell backward. The employee sustained a dislocated left shoulder, a fractured left wrist, a fractured lower right leg, and a laceration to the left eyebrow.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.