VULCAN GLOBAL MANUFACTURING SOLUTIONS, INC.

On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.

An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.

An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.

An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.

An employee's right hand was caught in a wire drawing machine, resulting in amputation.

An employee was adjusting the tension on a grinder belt when three of their fingers got caught in the belt and pulley and were amputated.

A employee's left index finger was pulled into a capstan, resulting in a partial amputation.

An employee was cutting a metal square on a hydraulic shear when his left hand got caught between the metal and the shear block. The employee's middle finger was amputated.

An employee was uncoupling railcars while the cars were in motion and a car ran over her left lower leg, resulting in crush injuries and amputation below the knee. The employee was hospitalized.

An employee was working to remove a piece of wood that was jamming a transfer conveyor at the shredder. He used a tool to clear the jam, then reached to grab the wood. His sleeve got caught in the conveyor and his right arm was pulled into the pulley. The employee was hospitalized with an open fracture and a crush injury/laceration to his right forearm. The machine was running at the time.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.