US Army Corps of Engineers, Walla Walla District

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was on a four-step work stand while sanding an area of an aircraft. He was climbing down the work stand when he tripped over an air hose and fell to the level below, resulting in a fractured femur.

An employee was lifting a manhole cover when it fell on his right foot, resulting in the amputation of his big toe and the adjacent toe.

A Bureau of Land Management (BLM) employee was assisting a fire crew with clearing a forest trail. The employee was struck in the left leg by a fire-rated chainsaw. The chainsaw struck the employee underneath their chaps and above their boot. The employee was hospitalized and required surgery.

An employee handed a fuel hose to another employee at a gas station pump and then turned around, tripped over the hose, and fell to the ground. The employee was hospitalized with a fractured hip.

An employee was conducting fire suppression operations on a wildfire. He pulled a hose from the engine. He then charged the hose and began to put on his gloves. A flareup occurred and the employee sustained burns to his face and hands.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.