Caught in running equipment or machinery during maintenance, cleaning · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Geiger Ready-Mix Co, Inc., 1333 South 2nd Street, LEAVENWORTH, KANSAS 66048
on — Crushing injuries, affecting the hand(s), unspecified.
Final narrative
An employee was performing cleaning activities on a concrete mixing drum with another employee. As he went to stop the drum from moving by placing a wheel chock, the roller and drum caught his glove and pulled his hand through, crushing it.
HospitalizedHand(s), unspecifiedAgitators, mixers-earth, mineral
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 327320)
An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.
An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.
A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.
An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.
A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.