An employee was performing maintenance on the refrigeration unit of a truck. As they were walking up a platform ladder, the ladder fell backward and the employee reached up with his right hand to hold onto something. The employee contacted the refrigeration motor belt, which pulled his index and middle fingers into a pulley, resulting in amputations to the first knuckle.
An employee was unhooking an air hose from an oil pump in a shop. As he disconnected the quick coupler, the compressed air caused an abrasion to his right ring finger.
An employee was performing a maintenance check when the reefer engine turned back on as the employee was checking the belt tension. The employee suffered open fractures to their hand and one finger.
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 532120)
An employee was working on disassembling and moving a trailer house from a gas well pad. The employee was on the roof of the structure installing flashing. The employee fell to the ground below, sustaining a skull fracture and brain bleed. The employee was hospitalized.
The injured employee had been working on the computer at the front desk in the showroom. An argument occurred with another employee and additional people got involved. Gunshots were fired. The employee was shot in the hip and was hospitalized.
An employee was preparing to remove leaf spring bushings on the front drive axle of a tandem axle tractor. After raising the axle with a hydraulic jack, he placed two jack stands under the rear frame rails of the tractor and placed additional jack stands under the front drive axle. He then repositioned himself at the rear of the tractor where he reached for the release valve of the jack to begin lowering the axle (and frame) onto the jack stands. He was in a kneeling position while using his right hand to operate the release valve. His left hand was caught between the lowering frame rail and a jack stand. His left ring and middle fingertips were crushed, resulting in amputations.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.