Other fall to lower level less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at SG ECHO, 2917 Big Lots Drive, DURANT, OKLAHOMA 74701
on — Fractures, affecting the hip(s).
Watch SG Echo — freeGet an email when a new federal OSHA severe-injury report for SG Echo is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was utilizing a portable ladder to enter the door of a manufactured home. He lost balance on the second step and fell to the concrete floor sustaining a broken hip.
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 321991)
On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.
An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.
An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.
An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.
An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.