Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Penske Truck Rental, 6890 Pecue Lane, BATON ROUGE, LOUISIANA 70817
on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was replacing batteries and spraying a battery protectant onto the batteries. The protectant reacted with the battery terminals, resulting in an arc flash. The employee was hospitalized with burns to their face, arms, and hands.
HospitalizedMultiple body parts, n.e.c.Battery-vehicle
An employee was performing maintenance on the engine of a box truck. He placed a socket wrench on top of the truck s cargo box and the wrench subsequently rolled out of reach. The employee climbed onto the top of the box to retrieve the tool. As he stood up, he was struck in the head by the operational engine fan. The employee sustained a laceration to his head.
An employee was changing the lower section of a truck's sliding rear door. The door moved and caught the employee's left index finger in its track. The fingertip was amputated.
An employee was closing the gate to a fenced-in vehicle lot when his hand was caught under the gate's roller resulting in amputation of the middle fingertip.
An employee was adjusting the lower radiator hose of a truck engine when the hose came loose. The employee was sprayed with hot radiator fluid on the top right side of his head and right shoulder resulting in burns.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 532120)
An employee was working on disassembling and moving a trailer house from a gas well pad. The employee was on the roof of the structure installing flashing. The employee fell to the ground below, sustaining a skull fracture and brain bleed. The employee was hospitalized.
The injured employee had been working on the computer at the front desk in the showroom. An argument occurred with another employee and additional people got involved. Gunshots were fired. The employee was shot in the hip and was hospitalized.
An employee was preparing to remove leaf spring bushings on the front drive axle of a tandem axle tractor. After raising the axle with a hydraulic jack, he placed two jack stands under the rear frame rails of the tractor and placed additional jack stands under the front drive axle. He then repositioned himself at the rear of the tractor where he reached for the release valve of the jack to begin lowering the axle (and frame) onto the jack stands. He was in a kneeling position while using his right hand to operate the release valve. His left hand was caught between the lowering frame rail and a jack stand. His left ring and middle fingertips were crushed, resulting in amputations.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.