GNP, Inc. Sheetmetal

On November 16, 2023, at around 3:30 p.m., a subcontracted employee was painting a door jam on a three-story house when he fell 20 feet through an opened elevator shaft to the floor below. The employee sustained fractured vertebrae that required hospitalization.

An employee was requested by a client to string wire on top of an auditorium. He used a boom lift to access a beam and then exited the boom lift to walk on the beam. He then stepped down on a drop ceiling, lost balance, and fell. The drop ceiling caved in and the employee fell 20 feet onto bleachers sustaining injury to his abdominal area and lower left leg. The employee was wearing a harness, but it was not connected to an anchoring point at the time of the fall.

An employee was installing decking (steel grates) in a new construction steel framed building. The employees were working approximately 22' above the next lower level, which was a concrete ground floor. The decking was pre-cut with the floor opening prior to installation. Shortly after installing the floor opening, the employee fell through the floor opening, approximately 18' onto a section of metal ductwork, resulting in fractures to the skull, ribs, thorax, and lumbar vertebra, as well as an ear laceration.

An employee was taking measurements of an area for drywall when they stepped backward into a partially covered hole in the floor. The employee fell approximately 17 feet to the level below, sustaining a forehead fracture and avulsion, a right shoulder dislocation, a left forearm fracture, left knee tendon and meniscus tears, as well as multiple contusions and abrasions.

An employee was stepping onto a temporary metal decking to hook up to his retractable when the C-clamp that was being used to temporarily fasten the metal deck slipped. A sheet moved and the employee fell through the stair landing 16 feet onto the landing below, resulting in clavicle and rib fractures as well as internal injuries.

An employee was using a 10-foot step ladder to install roller shades. The employee fell from the third rung from the top, landing on the ground and suffering back and head injuries. The employee was hospitalized.

An employee was climbing a ladder to access a home attic. The employee fell from the ladder to the ground, suffering a broken right elbow.

An employee was cutting a cast iron pipe when the pipe fell onto his right hand, resulting in amputation of the thumb. The employee was hospitalized.

While on a scaffold, an employee was transporting heated sealant material in a bucket. The employee tripped and fell, causing the heated material to splash onto his gloved hands. The employee sustained second-degree burns to both hands and his right wrist.

Three employees were pulling tension cable (similar to rebar) through the walls of a condo using a motor system. Two employees were needed to hold the cable while the third employee drilled the mounting locations. When the third employee activated the drill, the cables twisted. They caught the right index finger of one of the other two employees, amputating his fingertip.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.