Fall on same level resulting in exposure or contact · Thermal burns second degree
At a glance
Federal OSHA recorded a severe workplace injury
at Triple A Mountain Water Proofing, 1779 Airport Road Unit A, RIFLE, COLORADO 81650
on — Thermal burns second degree, affecting the Hand(s) and wrist(s).
Final narrative
While on a scaffold, an employee was transporting heated sealant material in a bucket. The employee tripped and fell, causing the heated material to splash onto his gloved hands. The employee sustained second-degree burns to both hands and his right wrist.
Hospitalized Hand(s) and wrist(s) Other constructed surface
A sanitation employee entered the chemical room and slipped on the wet floor. When he slipped, he kicked over a bucket containing cleaning chemicals. The chemicals splashed onto the employee's clothing and burned his skin.
An employee tripped while walking from one store register station to another. Her forehead struck a register, and she suffered fractures to two vertebrae in her neck. She was hospitalized.
An employee was using an electric pallet jack to retrieve a chemical tote from a staging lane. He inserted the pallet jack under the tote and began to back up. After moving backward for approximately 15 feet, the employee tripped on a collapsible tote. As he fell, the pallet jack ran over his left foot. His ankle was lacerated and his foot was fractured.
An employee had been unloading tires from the back of a pickup truck. The employee went to step down out of the back of the pickup truck and stepped on the lift gate in a vertical position. The lift gate tipped and employee fell, impacting their side on the upright liftgate. The employee sustained five fractured ribs and a punctured right lung. The employee was hospitalized.
An employee was using a 10-foot step ladder to install roller shades. The employee fell from the third rung from the top, landing on the ground and suffering back and head injuries. The employee was hospitalized.
Three employees were pulling tension cable (similar to rebar) through the walls of a condo using a motor system. Two employees were needed to hold the cable while the third employee drilled the mounting locations. When the third employee activated the drill, the cables twisted. They caught the right index finger of one of the other two employees, amputating his fingertip.
On May 1, 2025, an employee was cutting a pipe while working inside a trench that was 20' long x 3.5' deep x 4.5' wide. A shaft of dirt fell onto the employee's leg. The employee sustained an injury to their anterior tibial artery.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.