105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Crossland Construction Company, Inc.

Struck by falling object or equipment, unspecified · Amputations

Federal OSHA recorded a severe workplace injury at Crossland Construction Company, Inc., 2601 Parkway Drive, NORMAN, OKLAHOMA 73069 on — Amputations, affecting the fingertip(s).

An employee was removing a spandrel beam from a scissor lift. The employee lost hold of the spandrel beam and it fell on their left hand amputating the ring fingertip.

Amputation Fingertip(s) Beams-unattached metal

Crossland Construction Company Inc

An employee was helping to place a pin into a shoe bolt on a frame that was being raised and lowered by a forklift when material slipped and smashed the employee's left middle finger. The finger had to be surgically amputated.

CROSSLAND CONSTRUCTION COMPANY, INC.

An employee was operating a wire brush handheld grinder to smooth out concrete. The grinder hit the side of a stair and kicked back, hitting the employee's left leg and causing a 2" deep and 4" wide laceration on his thigh.

Crossland Construction Company, Inc.

An employee fell 18-20 feet through an uncovered hole in the roof while helping to install HVAC equipment. The employee was hospitalized for a facial fracture.

Crossland Construction Company, Inc.

An employee was cleaning a spray gun. He had mineral spirits in the gun and was adjusting the spray tip when the gun shot the mineral spirits into the skin on one of his fingers. The finger was surgically removed and the employee was hospitalized.

Crossland Construction Company, Inc.

An employee was installing guttering at a commercial construction site when he fell approximately 28 feet to the ground. He was hospitalized with a fractured vertebra and required surgery.

View Crossland Construction Company, Inc.'s full OSHA safety record →

Amazon FTW5

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

Tuff Shed, Inc.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

Lufkin Industries

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

Cy-Fair Coatings Inc

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

Rodriguez General Carpentry

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

Hobby Lobby Stores, Inc.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

Cross Management Corp.

An employee was installing insulation in a wall when she tripped on a hole (12" deep) and fell, hitting her head on the concrete floor. The employee sustained fractures to her leg and wrist, and lacerations to her head. The employee was hospitalized.

STEEL STRUCTURES AMERICA INC

An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.

Trejo Concrete & Steel, LLC

An employee was operating a power drill when it slipped. The drill bit punctured the employee's hand and they were hospitalized.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Meeco Sullivan

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

Edward Jones Investments

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

Burgess Manufacturing of Oklahoma Inc.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.