Pedestrian struck by forward-moving vehicle in nonroadway area · Fractures and surface, flesh wounds
At a glance
Federal OSHA recorded a severe workplace injury
at KAMPS, INC, 2300 JONESBORO RD SE, ATLANTA, GEORGIA 30315
on — Fractures and surface, flesh wounds , affecting the Foot(feet) and leg(s) n.e.c..
Final narrative
On January 2, 2024, the injured employee was working in a production area. He stepped down from a step stool and a forward moving forklift struck his left leg. The employee was hospitalized with a fractured left tibia and fibula, and a puncture to the left foot.
Hospitalized Foot(feet) and leg(s) n.e.c. Forklift, order picker, platform truck powered
An employee was operating a bubble wrap production line. He was splicing the ends of the film rolls together with tape when a driven roll contacted his hand. His hand and arm were pulled into the machine up to his shoulder. The employee's forearm contacted the the hot surface (230-500 F) of the bubble stamping cylinder. He was hospitalized with burns to the forearm that required surgery and crushing injuries to the hand and forearm without fractures.
An employee was operating a forklift to place two empty pallets onto a stack of empty pallets that was approximately 7.5 feet high. The employee placed the pallets on the stack, backed up, and then turned the wheel prior to lowering the forks. The forklift tipped over onto its left side. The employee's left foot became caught between the forklift and the concrete floor, resulting in hospitalization with a fractured foot.
On August 24, 2023, an employee was at a pallet repair table unjamming a portable nail gun. The nail gun discharged the jammed nail, striking the employee's left hand. They were hospitalized.
An employee was checking credentials for vehicles entering an area. While approaching a vehicle that had failed to stop as instructed, the employee lost his balance and fell backward, landing on his back. The car struck him, and he suffered a tailbone fracture and a kidney injury.
An employee was riding on the side of a forklift. He stepped off the forklift and was struck by the back end of the forklift as it turned to the right. The forklift's back tire ran over his leg, resulting in an amputation. The employee was hospitalized.
An employee was closing a rear trailer door in the parking lot when they were struck by a forklift. The employee's lower left leg was crushed between the pallet on the forklift and the trailer. The employee sustained muscle damage to their lower leg.
An employee was guiding a customer's automobile onto the alignment rack when the vehicle drove over the rack and pinned the employee against the alignment computer. The employee sustained a bruised left hand and a fractured left fibula and was hospitalized.
A backhoe tractor was moving gravel into a 1-foot-deep trench, and an employee was helping spread the gravel. The trench had been partly filled and the tractor was returning to it with a load of stone when its raised bucket struck the employee, who was standing in the trench. He was hospitalized, having suffered an abdominal injury that caused internal bleeding.
More severe injuries in this industry (NAICS 321920)
An employee was cutting wood with a miter saw when their clothing was pulled into the blade, resulting in a bicep laceration. The employee was hospitalized. The blade cover was not in place at the time of the incident.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.
An employee was operating a bubble wrap production line. He was splicing the ends of the film rolls together with tape when a driven roll contacted his hand. His hand and arm were pulled into the machine up to his shoulder. The employee's forearm contacted the the hot surface (230-500 F) of the bubble stamping cylinder. He was hospitalized with burns to the forearm that required surgery and crushing injuries to the hand and forearm without fractures.
An employee was operating a pallet dismantling saw. A board became stuck, and the employee tried to pull the pallet. When the board broke, the employee's right hand made contact with the blade, resulting in the amputation of the right middle finger above the second knuckle.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.