Federal OSHA recorded a severe workplace injury
at Cargill Corporation, 4700 North 132nd Street, BUTLER, WISCONSIN 53007
on — Amputations, avulsions, enucleations unspecified, affecting the Other finger(s) n.e.c..
Final narrative
An employee's left hand came into contact with a conveyor and was pulled around a conveyor guide. The employee's middle and ring fingers were amputated almost to the first joint. The little finger sustained an avulsion injury.
Amputation Other finger(s) n.e.c. Conveyors unspecified
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
More severe injuries in this industry (NAICS 311612)
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was using a de-clipping machine to cut the metal clips off of sausage sticks. As the employee put a link of sausages into the machine, their hand slipped into the point of operation. A piston pinched the employee's left index finger, causing a partial amputation.
An employee was operating a small tabletop grinder in a food safety quality assurance lab. She was stuffing meat down the grinder's chute when the grinder caught her right hand. Its auger caused an amputation to her middle finger and a partial amputation to her index finger.
A maintenance employee was removing an inspection plate from an industrial cooker. Hot liquid spilled onto him and burned his hands, arms, and torso area. He was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.