Cargill, Incorporated

An employee was performing regular job duties when they began to feel unwell. The employee was hospitalized for dehydration due to heat.

An employee was descending a ladder and fell approximately 5-6 feet to the floor, resulting in a fractured elbow.

An employee was unloading material from a rail car when they fell approximately 15 feet onto the feed layout area. The employee was hospitalized with a broken femur that required surgery.

An employee was attaching the paddle bone pull to remove the bones from a meat carcass. The paddle bone pull came down on the employee's finger, severing it. The tip of the finger was later reattached.

An employee was reaching to pull a piece of meat out of a vertical bandsaw when the bandsaw amputated the employee's right little fingertip.

An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.

An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.

After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was using a de-clipping machine to cut the metal clips off of sausage sticks. As the employee put a link of sausages into the machine, their hand slipped into the point of operation. A piston pinched the employee's left index finger, causing a partial amputation.

An employee was operating a small tabletop grinder in a food safety quality assurance lab. She was stuffing meat down the grinder's chute when the grinder caught her right hand. Its auger caused an amputation to her middle finger and a partial amputation to her index finger.

An employee was cleaning a part on a pedestal grinder. The employee's middle finger contacted the abrasive wheel, resulting in a partial amputation.

On September 25, 2025, an employee was operating a band saw that cuts gyro cones. The employee went to grab scraps and contacted the blade, resulting in a laceration to their left middle finger and an amputation to the left index fingertip.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.