Struck by dislodged or detached object(s) · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at National Pipe and Plastics Inc., 15 Mills Avenue, ENDICOTT, NEW YORK 13760
on — Fractures , affecting the Head and trunk.
Final narrative
A machine used to form PVC pipe began to jam up; the formed pipe began to bow. An employee cut the pipe, and a piece of it flew into another employee. That employee suffered a fractured left eye orbit, fractures to facial bones on the left side, and three fractured left-side ribs.
Hospitalized Head and trunk Pipes and tubes plastic, PVC, rubber
More severe injuries at National Pipe and Plastics Inc.
An employee was at the extruder pushing pipe down the line. As the employee was manually positioning a piece of pipe that was being heated, his finger was caught in an unguarded rotator chain resulting in an amputation.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 326122)
Employees were hooking up a new reel of pipe to be processed into shorter lengths. This process involved routing a winch cable through a haul-off and attaching it to the pipe using a clamp. One employee held the winch cable while another pressed the feed-out button to loosen the cable. The cable tightened and pulled the hand of the employee holding it into a pulley. The employee's right index and middle fingertips were amputated at the first knuckle.
On 8/22/2025, an employee was working to clear a grinder jam. The employee was using a "no-touch tool" to rotate the drum of the grinder. He slipped forward and his right hand contacted a pinch point between the backside of the blade and the grinder housing. The employee's right middle fingertip was partially amputated with bone loss.
At about 1:25 a.m. on August 14, 2025, an employee was operating a 10-inch band saw at a molding machine. The employee was working to cut the sprue off a PVC fitting. The blade snagged on the sprue and pulled his left index finger into the blade, which cut it. The finger was partially medically amputated.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.