Struck by falling object unspecified · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at TRK Enterprises Inc, 40.301 N 105.00 W, BERTHOUD, COLORADO 80513
on — Amputations involving bone loss, affecting the Other finger(s) n.e.c..
Final narrative
A rig crew had installed the rotating rubber onto the last joint of pipe in a mouse hole. The crew picked up the joint out of the mouse hole to attach it to the stump to make up the last joint. As the joint was placed inside the stump, the rotating rubber (wet from the weather) slid down the casing and struck an employee's right index finger. The finger was amputated.
Amputation Other finger(s) n.e.c. Parts and materials unspecified
An employee was holding a pup joint when a catwalk pushed the joint forward, causing it to strike their upper body. The employee suffered four broken ribs, internal bleeding from the pancreas, and bruises to their stomach and chest.
An employee was rigging down casing tools. He had two rig bales on the rig floor and was readying them to be let down to the rig floor. He had one bale upright when the rig-hand helper picked up the other bale and caught his ring finger between the two, partially amputating his distal fingertip.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
A temporary employee was rigging secondary steel when the steel joist fell to the ground and struck his lower left leg, resulting in fractures to the tibia and fibula.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.