Polyfoam, LLC

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was performing a maintenance task on a shape mold machine. The equipment had a clog preventing it from pumping material into the next stage. The employee's left hand was inside the hopper's butterfly valve when it unexpectedly turned. The employee's index and middle fingertips were partially amputated.

An employee was stacking used cardboard onto a pallet in the shipping and receiving area when he tripped over the scale by the loading dock door. The employee fell to the concrete floor and was hospitalized with a fractured left hip that required surgery.

On May 14, 2025, an employee was manually adjusting a plastic sheet entering the thermoforming oven when their right hand was pulled into the pin chain and idler wheel. The employee sustained the amputation of their middle finger.

At 6:30 p.m. on April 23, 2025, an employee was using a CNC panel saw when his fingers were pinned in by the pressure beam used to hold the board he was cutting. The sawblade, coming from beneath, amputated about 1/4 inch of his right little fingertip.

An employee was diagnosing an issue with a bagger that had jammed. The employee was cleaning out a piece of supporting equipment (a scrap barrel) when the blower motor contacted his right middle fingertip and fingernail, resulting in an amputation. The blower motor was not guarded at the time.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.