Atwood Distributing LP

An employee was walking in the feed area to retrieve straps when he stepped over a pallet and tripped over the cardboard. He fell to the ground on his left left hip and fractured it.

An employee was going outside to check a water pump after a rain storm. The ground was wet from both the rain and oil that had spilled from a cracked bucket; he slipped, fell to the ground, and suffered a broken left hip. He was hospitalized.

An employee was pulling on the handle of a pallet jack that was stuck on a pallet. When the pallet jack came unstuck, it caused the employee to fall backward and fracture his right hip on the ground.

An employee was standing on a bale of hay to pull a separate bale of hay from the top of a semi-truck bed for a customer. The bales of hay were held together by metal baling wire. When the employee went to undo the bale, the metal baling wire broke, causing him to fall off the hay bale and land on his left hip. The employee suffered a broken left hip.

An employee was operating an electric pallet jack when the pallet jack jumped backward, smashing her thumb between the pallet jack and a cardboard bailer. The employee suffered a crushing injury to her left thumb and a possible amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.

An employee was using a box cutter when it cut the tip of his left thumb resulting in a fingertip amputation.

While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.

An employee was using the pipe-and-wrench method to loosen a seized bolt on a roof truss. A technician from another company was on the other side of the truss doing the same action with the same method. The employee's socket slipped off the bolt and his left hand was crushed against the truss, resulting in injuries to the index and little fingers, requiring hospitalization, surgery, and amputation of the index finger.

An employee was backing up an electric pallet jack when it struck a yellow guardrail, pinning his ankle between the pallet jack and the guardrail. The employee suffered a crush injury to his left ankle and shin.

The injured employee was going to use an elevator to go upstairs. The elevator does not have a call button and is operated manually. The employee approached the elevator and used the elevator drop key located in the elevator key box to manually open the door. He then stepped forward into the elevator shaft. The elevator car was on another floor, resulting in the employee falling down the shaft from the first floor to the basement level. The employee was hospitalized with a sprained left hand and bilateral calcaneal fractures.

An employee was aligning a shipping offload conveyor. A component of the machine caught the employee's left middle finger, amputating it above the second knuckle.

An employee was using a torch to burn off liquid petroleum gas from old 100-pound cylinders so they could be recycled. When he went to move a tank, some gas spilled onto the ground, then ignited in a flash that engulfed him. He was burned on the face, hands, and back and was hospitalized.

An employee was escorting a forklift inside a store. While walking backward, the employee tripped on a pallet and fell, suffering a broken hip.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.