Fall on same level due to slip or trip · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Atwood Distributing LP, Atwoods of Lonoke, LONOKE, ARKANSAS 72086
on — Fractures , affecting the Hip joint(s).
Final narrative
An employee was going outside to check a water pump after a rain storm. The ground was wet from both the rain and oil that had spilled from a cracked bucket; he slipped, fell to the ground, and suffered a broken left hip. He was hospitalized.
Hospitalized Hip joint(s) Ground, travel, and support surfaces unspecified
An employee was walking in the feed area to retrieve straps when he stepped over a pallet and tripped over the cardboard. He fell to the ground on his left left hip and fractured it.
An employee was pulling on the handle of a pallet jack that was stuck on a pallet. When the pallet jack came unstuck, it caused the employee to fall backward and fracture his right hip on the ground.
An employee was opening freight boxes with a pocket knife when the knife slipped and contacted their index finger, resulting in amputation of the finger pad.
An employee was standing on a bale of hay to pull a separate bale of hay from the top of a semi-truck bed for a customer. The bales of hay were held together by metal baling wire. When the employee went to undo the bale, the metal baling wire broke, causing him to fall off the hay bale and land on his left hip. The employee suffered a broken left hip.
An employee was operating an electric pallet jack when the pallet jack jumped backward, smashing her thumb between the pallet jack and a cardboard bailer. The employee suffered a crushing injury to her left thumb and a possible amputation.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.
An employee was backing up an electric pallet jack when it struck a yellow guardrail, pinning his ankle between the pallet jack and the guardrail. The employee suffered a crush injury to his left ankle and shin.
The injured employee was going to use an elevator to go upstairs. The elevator does not have a call button and is operated manually. The employee approached the elevator and used the elevator drop key located in the elevator key box to manually open the door. He then stepped forward into the elevator shaft. The elevator car was on another floor, resulting in the employee falling down the shaft from the first floor to the basement level. The employee was hospitalized with a sprained left hand and bilateral calcaneal fractures.
An employee was aligning a shipping offload conveyor. A component of the machine caught the employee's left middle finger, amputating it above the second knuckle.
An employee was using a torch to burn off liquid petroleum gas from old 100-pound cylinders so they could be recycled. When he went to move a tank, some gas spilled onto the ground, then ignited in a flash that engulfed him. He was burned on the face, hands, and back and was hospitalized.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.