Canyon Service Company

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was coming from the parking lot at the start of his shift. He fell while walking in the crosswalk and sustained pain and numbness in his right leg. The employee was hospitalized and required surgery.

Employees had just finished re-lacing a line through a machine. As they were preparing to make a splice, one employee's left index finger was crushed between two pull rollers. The finger was amputated.

An employee was replacing a pop-up roller between the drop plate table and the far stacker conveyor after clearing a jam. The pop-up roller became hung up on the frame of the roller flight conveyor. The employee s hand then became caught between the pop-up roller and the belts on the drop table. The employee sustained an avulsion to their right hand excluding the fingers. The employee was hospitalized and required surgery.

On May 6, 2025, a temporary employee was loading a sheet of fiberglass between two rollers on a roofing material machine. The top roller was not rotating. The roller fell and pinched his left ring fingertip, causing a partial amputation of the finger that required surgery.

An employee was about to dump sand from a hopper, raised on the forks of a forklift. As the hopper's weight shifted forward and it began to dump, the employee's left middle finger was pinched between the forklift fork and the metal frame of the hopper. The fingertip was crushed, and the employee underwent a medical amputation at the first knuckle.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.