Struck by running powered equipment during maintenance, cleaning, testing · Soreness, swelling, inflammation
At a glance
Federal OSHA recorded a severe workplace injury
at BALON CORPORATION, 3419 S Mable, OKLAHOMA CITY, OKLAHOMA 73129
on — Soreness, swelling, inflammation, affecting the Other finger(s) n.e.c..
Final narrative
An employee was adjusting a light sensor on a machine when his hand got caught in the machine. This resulted in hospitalization from numbness and swelling in two fingers.
Hospitalized Other finger(s) n.e.c. Machinery unspecified
An employee was operating an engine lathe while reworking an engine part. The employee's right glove was caught by the lathe, resulting in an injury to the right middle finger that required medical amputation.
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
More severe injuries in this industry (NAICS 332911)
An employee was repositioning a large casting with a chain. The chain slipped and landed on his hand, resulting in hospitalization with a fracture to his upper arm and a crushing injury to his thumb.
An employee was performing a machine set-up and had installed one set of holding jaws. His right index finger became caught in an air vise while re-clamping a part. The employee sustained a partial amputation above the fingernail.
Two employees were re-packing a butterfly valve. The valve was being held by a crane. An employee added air to the valve to close it. The valve moved and the other employee reached to steady it. His thumb was caught in the valve and the thumb tip was amputated.
An employee was preparing to install a production tree/master valve. The employee grabbed the bull plug and shook the production tree into place. The well blew out on the casing side. The pressure caused the production tree to fall over onto the employee, resulting in a fractured right leg.
An employee was manually moving a 30-pound valve. When he sat the valve down, it crushed his left index fingertip just above the nail and amputated it.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.