An employee was using a sledgehammer to remove a large prop with a knocker that was attached to a boat when the sledgehammer broke and a metal chip flew into his eye. This resulted in a laceration to his eye that required surgery.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 713930)
A team of employees was moving boats from one slip in a marina to another using rope. An employee slipped while moving around in a boat and suffered a broken left femur.
An employee was at a guard shack checking in and directing guests. After motioning a camper forward, he turned to head back to the guard shack and the first rear tire of the camper struck his left foot and he fell to the ground. The second rear wheel went over his right leg, resulting in a fractured femur. The employee was hospitalized.
An employee helped to load garbage onto a boat. The boat bumped into a piling, causing the employee to fall in the water. The propeller of the boat lacerated his lower left leg from the knee to the foot.
An employee was assisting a boat owner with moving/pulling the owner s boat closer to a diesel dispenser for fueling. A gust of wind pushed the boat away from the dock while the employee was tying a line to a cleat to secure the front of the boat to the dock. His thumb became caught between the line and the cleat causing an amputation to the thumb.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.