Pedestrian struck by vehicle backing up in nonroadway area · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at S St. George Enterprises Contracting Inc., 601 Elmwood Avenue, ROCHESTER, NEW YORK 14618
on — Fractures , affecting the Lower leg(s).
Final narrative
An employee was hooking a roll-off container truck tow cable to a roll-off storage tank from between the truck's elevated guide rails and the metal tank. Their right leg became pinched between the guide rails and the metal tank when the truck backed up to get closer to the tank. This resulted in a fractured tibia and a laceration to the calf.
An employee was diagnosing the cause of a rear light malfunction on a forklift when the reverse gear engaged. The forklift moved backward and contacted the employee causing a metatarsal fracture in their left foot and injury to their lower right leg.
An employee was collecting shopping carts in the parking lot when he was struck by a customer's truck as it was backing out of a parking spot. The truck pinned the employee's left leg against the cart mule they were using. The employee was hospitalized with a fractured leg and required surgery.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.
An employee was between a milling machine and an 18-wheeler belly dump when the 18-wheeler backed up and ran over his feet and legs. The employee was caught between the front of the milling machine and the truck. The employee sustained fractures to their hip, leg, and feet.
More severe injuries in this industry (NAICS 237110)
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.
Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.
An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.