Beckwith Lumber Company

A maintenance employee was using a chain to lift a log out of the carriage area. The chain slipped off the log and the log struck the employee's left thumb, amputating the tip.

An employee was on break and went back out to the facility to begin work near the conveyor area. A piece of lumber came off the conveyor and caused the employee to sustain a left inner thigh laceration.

An employee was working on an edger chain. While the edger was shut off, the employee reached to straighten out a board on it; the edger was turned on and the employee's glove was pulled into the chain. The employee suffered a partial amputation to the left middle fingertip.

An employee was on a ladder, adjusting the upper limit switch for an ash expeller. He slipped off the ladder and his left ring finger was caught between the expeller piping and the moving ram cylinder, resulting in a finger fracture and an amputated fingertip.

An employee stood on a conveyor wall to unclog the cotton feeder. The employee fell on the moving conveyor and fractured his right arm. The employee was hospitalized.

Multiple employees were using baling buckets to remove 750 gallons of 150-degree hydraulic oil out of a pit in a confined space for approximately 5.5 hours. The injured employee was standing on a ladder performing this task when they fell feet-first into the hydraulic oil pit, resulting in burns on both legs.

An employee was climbing down a ladder. The ladder was unsecured and the employee fell, severely cutting his right arm on metal siding. He was hospitalized and required surgery.

An electrician was on a 9-foot scaffold performing valve maintenance on an 8-inch line near a heat exchanger. The electrician was working to cycle a valve that failed to close. Due to a misaligned drain line and an open manual valve, hot liquid dextrose (~250 F) was released onto the floor below, creating a steam cloud. The electrician was evacuating the scaffold using the scaffold ladder when they slipped and fell 5-6 feet into the hot liquid, sustaining first- and second-degree burns to multiple parts of their body including both arms, both hands, their back, and their buttocks.

An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.

An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.

An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.

An employee was working to get a log back onto a carriage. The employee came into contact with the running saw, which amputated their arm.

While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.