Fall to lower level resulting in exposure or contact unspecified · Thermal burns second degree
At a glance
Federal OSHA recorded a severe workplace injury
at C&W Facility Services, Inc., 650 Industrial Park Drive, BLAIR, NEBRASKA 68008
on — Thermal burns second degree, affecting the Trunk and other upper extremities.
Final narrative
An electrician was on a 9-foot scaffold performing valve maintenance on an 8-inch line near a heat exchanger. The electrician was working to cycle a valve that failed to close. Due to a misaligned drain line and an open manual valve, hot liquid dextrose (~250 F) was released onto the floor below, creating a steam cloud. The electrician was evacuating the scaffold using the scaffold ladder when they slipped and fell 5-6 feet into the hot liquid, sustaining first- and second-degree burns to multiple parts of their body including both arms, both hands, their back, and their buttocks.
Hospitalized Trunk and other upper extremities Scaffolds, staging unspecified
More severe injuries at C&W Facility Services, Inc.
An employee's hand was caught in a conveyor belt as they worked to clear a jam in a piece of equipment. The employee suffered a dislocation to the right elbow, as well as a broken ulna near the elbow, and was hospitalized.
An employee was remotely operating a scissor lift out of a low-ceiling garage when the right front wheel of the lift ran over the heel of his left foot, causing soft tissue damage. The employee was hospitalized and required surgery.
An employee was performing janitorial duties when their finger became caught between a full-sized dumpster and a metal pipe on the wall. The employee sustained a fingertip amputation.
An employee was cutting a foam board with a portable table saw when their hand slipped and the saw blade partially amputated their right little finger.
An employee was doing grounds maintenance with a tractor, and was out of the tractor when it rolled, pinning the employee against a steel fence post. The employee was hospitalized with five broken ribs and right arm injuries.
An employee was on a ladder, adjusting the upper limit switch for an ash expeller. He slipped off the ladder and his left ring finger was caught between the expeller piping and the moving ram cylinder, resulting in a finger fracture and an amputated fingertip.
An employee stood on a conveyor wall to unclog the cotton feeder. The employee fell on the moving conveyor and fractured his right arm. The employee was hospitalized.
Multiple employees were using baling buckets to remove 750 gallons of 150-degree hydraulic oil out of a pit in a confined space for approximately 5.5 hours. The injured employee was standing on a ladder performing this task when they fell feet-first into the hydraulic oil pit, resulting in burns on both legs.
An employee was climbing down a ladder. The ladder was unsecured and the employee fell, severely cutting his right arm on metal siding. He was hospitalized and required surgery.
An employee was working to string cable at a temporary asphalt facility. He had been taking cable from the silos to the control room. He used a ladder to get to another silo and connect a cable. He slipped on the ladder and fell. A cable-supporting hook next to the ladder impaled and tore his right bicep. The employee required surgery.
More severe injuries in this industry (NAICS 811310)
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.