Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at All-Star Transportation - New Milford, 7 Dodd Road, NEW MILFORD, CONNECTICUT 06776
on — Fractures , affecting the Part of body unspecified.
Final narrative
Three employees were cleaning the shop and were putting an engine stand above the office into storage. Two of the employees rolled the engine stand onto the forks of a forklift. One employee got on top of the forks and was holding the engine stand in place with the forks elevated. When it got to the second stage there was a bump that caused the engine stand to dislodge and both the employee and the stand fell to the ground approximately 6 feet below. The employee sustained broken bones and was hospitalized.
Hospitalized Part of body unspecified Forklift, order picker, platform truck powered
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 485410)
An employee finished her afternoon shift and was walking to her car on the gravel/dirt/grass walking surface. As she approached the exit gate, she tripped/stumbled and fell onto a nearby fence and the ground. The employee sustained fractures to collarbones or rotator cuffs on each side of her shoulder(s).
A maintenance employee was working on a bus at the maintenance shop when he tripped and fell on a wheel chock. The employee was hospitalized with a fractured hip and required surgery.
An employee was performing a pre-trip inspection of a bus. He was walking down the bus steps using the handrail when he slipped and fell, resulting in back injuries, internal bleeding, and a severe hematoma.
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.