Patricio's Construction Inc

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was on an extension ladder descending from a roof when the ladder collapsed and lowered. The employee fell approximately 20 feet to the ground, resulting in fractures to their ribs and left wrist.

The injured employee was acting as a spotter for another employee that was using a forklift to move crane plates. The injured employee went to walk on top of staged bracing poles that had been stacked. The top layer of bracing shifted when stepped on, causing the employee to lose balance and fall. During the fall, one of the bracing poles dislodged and landed on the employee s left leg, causing a compound fracture.

An employee was working to remove an existing window from a customer's home. The employee was descending an extension ladder when they fell backward onto a concrete patio. The employee sustained head trauma and fractures to their shoulder, ribs, and a vertebra.

An employee was painting the exterior of a house when they fell approximately 12 feet from a ladder. They landed on the ground and sustained a fractured right ankle.

An employee climbed a ladder onto a roof, then stepped from new roof sheathing onto a tarped section of old roof, and fell to the ground. The employee suffered fractures to their pelvis, vertebrae, and the left wrist. The employee was hospitalized.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.