Jennings Painting Inc.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was on a 12-foot extension ladder while painting the wall and soffit area of a pavilion less than 6 feet off the ground. The employee was using a sprayer when he fell off ladder and landed on his arm on the dirt clay ground. The employee sustained a dislocated elbow and fractures to his right arm and wrist that included an open fracture. The employee was hospitalized and required surgery.

An employee was blasting a water tower. They fell approximately 60 feet off a suspended scaffold and sustained broken vertebrae, a compound fracture of the tibia, a fractured heel, and a rupture to their liver. The employee was hospitalized.

An employee was sandblasting paint from a water tower when the blasting media sprayed across their forearm, resulting in an elbow injury that required hospitalization.

An employee was working from a boom lift, painting wood trim at a second-story roof level. The lift drove over an unmarked dry well, tipped, and catapulted the employee to the ground. The employee sustained fractures to their heels and vertebrae. Fall protection was not being worn at the time of the incident.

On October 2, 2025, an employee was ascending a ladder attached to a scaffold structure approximately 10 feet high. While climbing up, he lost his grip on a rung and fell to the ground, landing on his shoulder. He was hospitalized with fractures to his collarbone and shoulder.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.