Bracken Construction

An employee was transitioning a bolt keg from a hand dolly to storage when the metal can began to roll. The can impacted a stored can and the employee's right index finger was caught between the two cans, resulting in a fingertip amputation.

While decking on the roof, an employee became overheated and required hospitalization for heat exhaustion.

A sanitation employee entered the chemical room and slipped on the wet floor. When he slipped, he kicked over a bucket containing cleaning chemicals. The chemicals splashed onto the employee's clothing and burned his skin.

An employee tripped while walking from one store register station to another. Her forehead struck a register, and she suffered fractures to two vertebrae in her neck. She was hospitalized.

An employee was using an electric pallet jack to retrieve a chemical tote from a staging lane. He inserted the pallet jack under the tote and began to back up. After moving backward for approximately 15 feet, the employee tripped on a collapsible tote. As he fell, the pallet jack ran over his left foot. His ankle was lacerated and his foot was fractured.

An employee had been unloading tires from the back of a pickup truck. The employee went to step down out of the back of the pickup truck and stepped on the lift gate in a vertical position. The lift gate tipped and employee fell, impacting their side on the upright liftgate. The employee sustained five fractured ribs and a punctured right lung. The employee was hospitalized.

An employee fell onto a hot billet and suffered a burn to the left leg. The employee was hospitalized.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.