Struck against stationary object n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Carew Concrete Products, 244 W Pioneer Road, FOND DU LAC, WISCONSIN 54935
on — Amputations, avulsions, enucleations unspecified, affecting the Other finger(s) n.e.c..
Final narrative
An employee was standing on the front bumper of a ready-mix concrete truck cleaning the windshield. The employee went to jump off the bumper and suffered a degloving injury to their left ring finger when their wedding ring became caught in the bottom of the overhead access platform, resulting in medical amputation.
Amputation Other finger(s) n.e.c. Vehicle and machine platforms, surfaces
An employee was cleaning the pretzel oven when the edge of a rack in the oven contacted their right thumb, resulting in a laceration that required hospitalization and surgery.
An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.
An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.
An employee bent down to turn on an air valve, lost their footing, and struck their hand on a pressure relief valve while trying to catch themselves. The employee suffered an amputation to their right index fingertip.
An employee was helping to hold a rope that was tied around a pine tree where dead branches were being removed. As a branch was removed, the tree swung, causing the employee holding onto the rope to swing, slide across the grass, and strike the bumper of a nearby truck. The employee sustained a lower leg fracture.
More severe injuries in this industry (NAICS 327320)
An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.
An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.
A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.
An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.
A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.