Struck against stationary object n.e.c. · Cuts, lacerations, punctures without injury to internal structures
At a glance
Federal OSHA recorded a severe workplace injury
at ORSA Technologies, White Sands Missile Range, WHITE SANDS MISSILE RANGE, NEW MEXICO 88002
on — Cuts, lacerations, punctures without injury to internal structures, affecting the Hand(s), finger(s) unspecified.
Final narrative
An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.
An employee was cleaning the pretzel oven when the edge of a rack in the oven contacted their right thumb, resulting in a laceration that required hospitalization and surgery.
An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.
An employee bent down to turn on an air valve, lost their footing, and struck their hand on a pressure relief valve while trying to catch themselves. The employee suffered an amputation to their right index fingertip.
An employee was helping to hold a rope that was tied around a pine tree where dead branches were being removed. As a branch was removed, the tree swung, causing the employee holding onto the rope to swing, slide across the grass, and strike the bumper of a nearby truck. The employee sustained a lower leg fracture.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
On 7/31/2025, an employee was training to ride an ATV when it went into a draw and she went over the front of the ATV, landing on the ground. The employee sustained a fractured arm.
An employee was standing behind a frac pump. A discharge hose failed and the employee was burned by hot water on the left upper abdomen. The employee was hospitalized.
An employee working as a contracted firefighter was using a bulldozer to push back an active fire line when they became entrapped in flames, resulting in first- and second-degree burns.
An employee was assisting with the delivery of pipe racks to the drilling rig. The driver was releasing the tie-down lock straps that were holding the pipe racks on the trailer. When the last strap was released, one of the pipe racks rolled off the trailer and struck the employee while they were on the passenger side of the trailer bed. The employee sustained an open wound to the hand and fractures to their left leg and spine.
On May 1, 2025, at approximately 11:00 AM, an employee was jump-starting the battery of a forklift and his back went out while he was bending down. The employee was hospitalized with a slipped disc and required surgery.