STARTKLEEN LEGACY, LLC

An employee was cleaning a two-axis mixer when her left hand was caught in the paddles and her index and middle fingers were amputated.

An employee was cleaning a chicken breast processor. A hook caught her hand and pulled it toward a pulley that lacerated it, tearing tendons and an artery. The machine was not locked out at the time of the incident.

An employee's finger became caught in a conveyor belt, resulting in a partial fingertip amputation.

An employee was cleaning a tenderizing machine. The employee's hand was caught in the rotating chain and sprocket, causing an amputation to the middle finger past the second knuckle.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

An employee was rinsing a food processing machine at a facility and went to stabilize himself. His left hand contacted the surface of the machine and a guard inadvertently closed, crushing the tip of his ring finger and resulting in an amputation and fracture.

An employee was performing janitorial duties on the 15th floor of a building that was under construction. She began having trouble breathing. The employee was hospitalized with lung irritation caused by dust.

On October 17, 2025, an employee was descending a fixed two-step stool when she slipped, landed on her left leg, and suffered a broken femur. She was hospitalized, requiring surgery.

An employee slipped while getting on a trailer. His chin struck the trailer jack, and he suffered fractures to his jawbone and thyroid cartilage. He was hospitalized, requiring surgery.

A crew was finishing work for the day at a job site. An insulated modular panel (IMP) being used as a door fell on an employee. She suffered a dislocated shoulder, a broken arm, and a gash on her left leg. She was hospitalized, requiring surgery for the arm/shoulder injury.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.