D&D Commodities Limited

An employee was packaging birdseed when a piece of poly got stuck inside the machine. The employee attempted to clear the piece off the machine when a pulley on the machine contacted their right index finger, resulting in a fingertip amputation. The machine was not locked out/tagged out at the time of the incident.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was working on removing the gearbox from the drive shaft of the motor assembly of a feather drier. He was using a hydraulic tool to pull the pieces apart when a bolt dislodged from the eye of the gearbox and the corner of the gearbox broke off. The employee was struck in the nose (sinus cavity), resulting in hospitalization and surgery.

An employee was on a forklift checking the sprinkler system drain. The employee fell 8 feet from the forklift to the floor. The employee suffered a broken collar bone and was hospitalized.

An employee was working as a dumper on a packaging line. A passing forklift turned and pinned the employee against a guardrail. The employee suffered fractures to their ribs and a leg requiring hospitalization.

An employee was cleaning an upper mezzanine. When he leaned against the mezzanine gate, he fell through the gate opening and landed 11 feet below. The employee sustained fractured orbital bones.

An employee was assigned to clean a feed mill in the basement. He then rode a tool and material basket to return from the basement to the ground level. He fell out of the basket and landed about 5 feet below. The employee sustained fractures to his arm, lower back, and foot.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.