Struck by dislodged or detached object(s) · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at IMAR Construction , LLC, 332 Rachel Ln. Lot#36, HARTWELL, GEORGIA 30643
on — Fractures , affecting the Trunk and other lower extremities.
Final narrative
An employee was working with a concrete boom pump. While they were maneuvering the hose/handle, the truck-mounted arm snapped off and the hose landed on top of the employee. The employee sustained a right leg fracture, broken ribs, and lacerations to the left shoulder, face, and the back of the head.
Hospitalized Trunk and other lower extremities Hoses except machine
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 236115)
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.