Holt Texas, LTD.

An employee was working on a 6-foot ladder that was leaned against a gas compression engine. The ladder feet slipped on the working surface, causing the ladder to become unstable. The employee fell off the ladder and suffered bilateral wrist fractures.

An employee was replacing a hydraulic cylinder on a scraper. The cylinder released pressure, causing it to fall and impact a wooden block. The wooden block split and the employee was struck by shrapnel from the wood, resulting in a right wrist dislocation.

An employee was using a torque multiplier ratchet wrench to loosen a bolt. The wrench broke and struck him in the arm, breaking the forearm. He was hospitalized and underwent surgery.

An employee was replacing a cable on a truck-mounted crane when the employee's left thumb was caught between the crane's drum and mounting bracket, amputating the tip.

An employee was repairing equipment at the job site and became overheated.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

A mechanic was replacing the airbag suspension on the front axle of a utility trailer. The airbag blew out, causing an injury to the mechanic's left foot that required hospitalization and surgery.

Employees were installing a truck scale and lowering a module when the injured employee's right ring finger was caught between the module and a side rail. The employee sustained an amputation of the finger to the first knuckle.

An employee was servicing an air handler at ground level when their left hand contacted a rotating belt. The employee sustained a fingertip amputation.

An employee was calibrating a 100-ton transfer rail using a forklift attachment referred to as an evener which was a metal lifting device. The employee was holding the evener up so that another employee could slide the forklift tines under the evener bar and lift the calibration blocks. During this process one of the forklift tines pinched the employee s right ring finger between the tine and the evener bar resulting in a fingertip amputation.

An employee was performing maintenance when his left hand was caught in a conveyor belt. Their left hand and fingers were crushed and lacerated.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.