Keith Weighing Systems, LLC

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

A mechanic was replacing the airbag suspension on the front axle of a utility trailer. The airbag blew out, causing an injury to the mechanic's left foot that required hospitalization and surgery.

An employee was using a 40-ton press to remold a steel part when a steel plug guide shot out from the press and struck the employee in their midsection, causing three broken ribs and a hematoma.

An employee was servicing an air handler at ground level when their left hand contacted a rotating belt. The employee sustained a fingertip amputation.

An employee was calibrating a 100-ton transfer rail using a forklift attachment referred to as an evener which was a metal lifting device. The employee was holding the evener up so that another employee could slide the forklift tines under the evener bar and lift the calibration blocks. During this process one of the forklift tines pinched the employee s right ring finger between the tine and the evener bar resulting in a fingertip amputation.

An employee was performing maintenance when his left hand was caught in a conveyor belt. Their left hand and fingers were crushed and lacerated.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.