Other fall to lower level 6 to 30 feet · Traumatic injuries or exposures unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Sky Chefs, Inc., 200 E Touhy Ave., DES PLAINES, ILLINOIS 60016
on — Traumatic injuries or exposures unspecified, affecting the Neck and back.
Final narrative
An employee had provided catering to an airplane and was preparing to descend the elevated box truck. They walked out of the rear door and fell 15 feet to the ground sustaining injuries to the neck and back.
Hospitalized Neck and back Trucks with other mounted machinery, equipment n.e.c.
A catering team had just finished serving an aircraft and were participating in training tasks. The truck box was lowered when it was stopped midway, approximately 10-12 feet off the ground. The back door was opened and the injured employee fell to the concrete below, resulting in two wrist fractures.
An employee was switching out a motor during a repair service when the motor fell onto the employee's hand, resulting in a fracture and amputation to a finger.
An employee was setting up wheel chocks on the tire of an aircraft. The vehicle that was going to be used to load catered food onto the aircraft deployed its stabilizing outriggers. The outriggers crushed the first digit of the little toe on the employee's left foot.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 722320)
An employee was sitting on a milk crate at the back of a loading dock while talking to another employee. She noticed the other employee began shaking. She went to prevent the other employee from falling when she fell off the dock to the concrete ground, resulting in multiple body injuries that required hospitalization.
Two employees were working in the kitchen area of a food trailer. There was a sudden burst of fire in the kitchen, and both employees were engulfed by deflagration of gas which oriented from a propane-powered griddle. They suffered first-, second- and third-degree burns to their head, face, arms, and legs.
An employee loaded his truck. The dock plate was stuck under the carrier dolly and he could not lift the dock plate from the side while standing on the dock. The employee entered the truck and pushed the dolly away from the dock plate. This allowed him to lift the plate from inside the truck. While lifting the plate, his body shifted forward, and he fell between the dock and the truck, resulting in a fractured left wrist.
The injured employee had been conducting food service activities. He was stabbed twice in the chest and three times in the back by another employee using a pocket knife. The employee was hospitalized.
On April 2, 2025, an employee was reassembling a food-sealing machine when the machine activated and a metal plate pinched their right thumb tip, amputating it. The machine was not locked out/tagged out at the time.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.