Boyd Company

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was replacing the cutting edges on the bucket of a wheel loader. The bucket had been lowered onto composite blocking to prevent it from falling to the floor. The blocking dislodged and the bucket fell and crushed the employee's left hand.

An employee was walking on top of a piece of equipment while engaged in repair activities. The employee stepped onto a rotating impeller shaft of a belt-driven exhaust fan and sustained a partial amputation to their right leg below the knee and amputation of their left hand.

An employee was installing an automobile lift at a client location and put the lift on a safety lock. The employee's right hand was caught in the lift and crushed, causing the amputation of the little finger at the last knuckle and all of his right fingers were fractured.

On April 18, 2025, an employee was cutting the lid off an empty 55-gallon drum using a plasma cutter. The drum originally contained a flammable liquid and residual liquid inside the drum ignited and exploded. The employee was hospitalized with burns to the face, chest, and arms.

An employee was unlocking a yard gate from within a car. His finger was caught between the gate and the car, and the fingertip was amputated.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.