Other fall to lower level 6 to 30 feet · Fractures and soft tissue injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Paccar Engine Company, 1000 Paccar Drive, COLUMBUS, MISSISSIPPI 39701
on — Fractures and soft tissue injuries, affecting the Multiple body parts n.e.c..
Final narrative
An employee had removed a platform grate to expose the equipment below and replace a broken shaft. The employee slipped and fell backward through the open grate, falling approximately 12 feet to the floor. They sustained fractures to their skull, T1 vertebra, right shoulder, and rib, as well as a torn anterior cruciate ligament (ACL).
Hospitalized Multiple body parts n.e.c. Vehicle and machine platforms, surfaces
An employee was pushing an engine block onto a conveyor when their right thumb was pinched between the engine block and a clamp inside a machine. The employee sustained a laceration and an open fracture to the thumb.
An employee was pulling an engine block onto a steel plate when the employee's left hand was caught in the path of the moving engine block, amputating the middle fingertip.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 333618)
An employee was moving a hoist to the end of a bridge rail to create space for another hoist on the same rail. The hoist being moved, along with its supporting beam, detached from the bridge rail and fell, striking the employee in the head. He suffered a contusion and laceration to the head and was hospitalized.
An employee was operating a machine. When they performed a motion to push a machined engine block away from their body, they experienced a back strain, resulting in hospitalization.
On September 13, 2025, an employee had been working at an outdoor event. At the end the day, she was walking around outside the facility to make sure everything was put away and felt overheated. The employee was hospitalized for heat-related illness.
An employee was installing insulation in a wall panel when the panel fell on top of them, resulting in leg and back injuries that required hospitalization.
An employee put a cylinder machining pallet into manual mode to unjam it. After completing the task, their left hand became lodged between a pulley and belt, resulting in the amputation of three fingers.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.