DAY AND ZIMMERMANN, INCORPORATED

An employee was conducting a safety inspection of the room and fell from a fixed access ladder after receiving an arc flash burn to his forearm. The employee suffered a broken ankle from the fall off the ladder.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was walking to leave the worksite, slipped on mud, and fell to the ground. The employee suffered a C5 vertebra fracture that required surgery.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.