Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at NOUVEAU ELEVATOR INDUSTRIES INC, 290-300 Broad Hollow Road, MELVILLE, NEW YORK 11747
on — Electrical burns any degree , affecting the Hand(s) and arm(s) n.e.c..
Final narrative
An employee was drilling a ground terminal lug when the drill hit the mainline. An arc flash occurred and the employee sustained burns to their left arm and hand requiring hospitalization.
Hospitalized Hand(s) and arm(s) n.e.c. Electric parts unspecified
More severe injuries at NOUVEAU ELEVATOR INDUSTRIES INC
The injured employee was replacing hoist cables in an elevator pit when a hand tool from another employee working on the elevator car top fell down the elevator shaft and struck him in the head, knocking his hard hat off. Then, a second tool hit him on the top right front of his skull resulting in a fracture.
An elevator mechanic was adjusting the elevator brake clearance with a feeler gage used to monitor clearance between the brake shoe and operating shaft. The mechanic was holding the feeler gage in his left hand, and wrenches in his right hand. He instructed a helper inside the elevator to cab up. As the cab went up, his left middle finger got pinched in the elevator hoist cable and the fingertip was amputated.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.
An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.
On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.
An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.