American Woodmark

An employee was riding on the side of an all-terrain forklift when they fell into the space between the gas tank and the right rear tire. The employee was run over by the the right rear tire, resulting in fractures to their neck, pelvis, and right leg.

Employees were moving a paving machine. The machine had been pulled forward, then put in reverse to back up a hill, when it revved up and went out of control. It had moved about 40 feet when one employee jumped out of it and was dragged under it. A second employee rode about another 40 feet, then jumped out to avoid a steep embankment. The first employee suffered a broken pelvis, and the second employee suffered a broken lower leg. Both were hospitalized.

An employee was operating a lawn mower. He fell off while making a turn and the mower ran over his right foot. The employee sustained a laceration on his right ankle.

An employee was driving a forklift. He fell off the machine during a turn, and one of its wheels broke his left foot. He was hospitalized.

An employee was traveling on a walker rider as it headed for the outer wall of the warehouse office. He jumped off the front of the rider which caused his legs to be caught between the base of the rider and the yellow safety rail. The employee sustained a fractured right fibula.

On May 9, 2025, an employee was using an air hose to clear debris from the courtyard area when she slipped and fell. The employee was hospitalized with closed fractures to her left fibula, tibia, and medial malleolus.

On April 24, 2025, an employee was opening a cylinder door on a hydraulic bridge to remove lumber when their left middle finger was caught between the door and the hydraulic bridge, resulting in an amputation without bone loss.

Two employees were using a plywood chop saw. The injured employee was holding one end of the saw with their right hand when the operator on the other end pressed the start button. The saw blade contacted the injured employee's right hand, resulting in multiple finger amputations when it amputated the hand above the thumb.

On January 17, 2025, at 12:15 p.m., an employee was moving 11-gauge steel sheets from a holding cart using a pendant-controlled, 1-ton jib hoist equipped with a plate clamp lifting attachment. With the plate clamp empty and open, the employee began raising the hoist. The clamp became caught on the bottom of the cart, tipping the cart in the direction of the employee. Several sheets of steel slid off the cart and struck the employee, resulting in several broken ribs, a broken left leg and ankle, a fractured kneecap, and a torn left ACL. The employee was hospitalized.

An employee was operating an air hoist to rotate a blending mill counter-clockwise. After he connected the hook to the mill, the hoist was raised and his hand was pinched between the hook block and the ring on the mill. The employee sustained a partial amputation of his right thumb.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.