Nonroadway noncollision fall or jump from moving vehicle · Intracranial injuries unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Casella Waste Systems, Inc., Route 202 Auburn Maine 439-587 ME-100 Washington St N, AUBURN, MAINE 04210
on — Intracranial injuries unspecified , affecting the Brain.
Final narrative
An employee was riding on the back of the dump truck in the engineered location and fell to the ground. The employee suffered a head injury that bled, lost consciousness, and sustained a fractured shoulder.
Hospitalized Brain Dump trucks
More severe injuries at Casella Waste Systems, Inc.
An employee was pushing a baler door that weighed about 500 pounds closed. A pair of wire cutters fell between the door and the baler wall. The employee was retrieving the wire cutters when the door closed, crushing the employee's right index finger against the baler wall and causing a partial amputation to the finger.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was riding a four-wheeler while moving cattle into another pen when they were thrown off the vehicle and landed on the ground. The employee sustained fractures to their upper arm, pelvis, and right leg.
An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.
Two employees were operating a paving machine at approximately 1 mile per hour. The paver made a sudden turn, that threw the injured employee off balance. He reached for the handhold next to him and missed, falling 6 inches off the platform to the ground. The adjustable handle for the wing on the paving machine went between his left-hand fingers with the full weight of his body. The employee suffered a closed fracture of the fourth metacarpal bone in his hand.
More severe injuries in this industry (NAICS 562119)
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was preparing to dump wood from a roll-off dumpster when a piece of timber fell from the dumpster and struck the employee in the head. The employee sustained a laceration to the scalp and three cracked vertebral discs.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.